Q: The base station how to power generator?

A: generator can be divided into two kinds, the base stationOne isStationary, at a fixed base station computer room is equipped with a diesel generator.Two is mobile, in computer room equipped with generators and requires human drag to the generator room.

One, the base station stationary generator to produce electricity

If there is no assembly stations stationary generatorRemote monitoring system of generator, when the city shut down, also needs the human to base station room, artificial power, namely of his Labour, the key is to increase a lot of cost, it is not convenient for management.

Equipped with remote monitoring system of base station generator power generation, multiple base stations can be remote monitoring power, which is convenient, nodes with human cost and management cost greatly.Steps are as follows:

1, the system will automatically detect the utility power failure.

2,Start automatically detect oil machine power conditions.

3, through Wireless data transmission module(DTU) automatically detect oil oil, oil pressure, voltage and other parameters.

4,Base station generator automatic remote monitoring system of ATS switch to oil machine to generate electricity.

5, the mains, generator outage, the system automatically switch to the mains power again.

Second, the base drag type generator to produce electricity

1, move the oil machine to the outside of the room, check for gasoline or diesel oil inside the machine, and see if the oil is normal;

2, use multimeter test for a power grid;If power, turn off the mains switch (separation), the general is the largest open communication distribution box inside;

3, the best leader in the power line connected to the generator of aperture, and the other end to open access to the output terminal;

4, start the machine oil, machine oil to be panhao work normally and then close the power switch;

5, check the base station switching power supply module can work normally;

6, mains, first close the oil machine power switch, then oil machine switch, and then to dismantle the power distribution box on the end of the line, the second demolition generator to the power generation, now finally listed the electric switch, check again switch power supply module, see can normal work.Special note: generator power must not be put in the telecom room;

7, must first turn off the power mains switch;

8, when recovery mains must turn off the oil machine, dismantle again after the listed electric power line switch.